{"id":11061,"date":"2022-09-25T23:52:37","date_gmt":"2022-09-25T20:52:37","guid":{"rendered":"https:\/\/starlanguageblog.com\/?p=11061"},"modified":"2022-09-25T23:52:37","modified_gmt":"2022-09-25T20:52:37","slug":"how-to-fix-a-bubble-in-drywall-taping","status":"publish","type":"post","link":"https:\/\/www.starlanguageblog.com\/how-to-fix-a-bubble-in-drywall-taping\/","title":{"rendered":"How to Fix a Bubble in Drywall Taping"},"content":{"rendered":"

How to Fix a Bubble in Drywall Taping<\/span><\/h1>\n

Poor installation is the only explanation for bubbles developing behind the drywall tape. Because the joint compound was not fully imbedded on the tape, bubbles formed. Most individuals will try to hide the bubbles with a new layer of compound.<\/p>\n

To fix a drywall tape bubble, first chip off any hardened joint compound on top of the bubble. Then, cut out and remove the bubbled area of tape. Spread joint compound over the drywall seam using a putty knife, then apply a new piece of tape over the space where you removed the bubble.<\/p>\n

You’re not alone if you’ve ever wondered how to fix a bubble in drywall taping. The problem can be frustrating, especially if you’re in the middle of a vast project. However, some easy fixes can solve your problem. One of these is to use drywall compound. You can buy a 2-inch tube and apply it with a putty knife. Once the compound is applied, smooth the edges and let it dry overnight. Then, you can repeat the procedure the following day.<\/span><\/p>\n

Using a Rotary Tool<\/span><\/h2>\n

One of the first steps you need to take when trying to fix a bubble in drywall tape is to cut the bubble out. You can do this by using a utility knife. But, cut the tape away from the bubble by about half an inch (1 cm), so you can overlap the new tape on both sides.<\/span><\/p>\n

Next, use a putty knife to cut off the bubbled portion of the tape, leaving at least one inch of the tape on either side of the bubble. This section will be replaced later. This step is crucial as the bubble can cause further damage to the wall, which will make the patching job more difficult.<\/span><\/p>\n

Sometimes, a bubble is caused by too much moisture in the wall. This causes the tape not to seal correctly, leading to larger bubbles. If the area is too moist, use a dehumidifier to remove the excess moisture in the walls.<\/span><\/p>\n

The next step is to use a putty knife to smooth out the new tape. The new piece of tape mustn’t have bubbles. You want to make sure it is flat over the joint compound. Using a putty knife can also help you ensure that there are no air bubbles in the new piece of tape.<\/span><\/p>\n

Applying Drywall Mud<\/span><\/h2>\n

The first step in repairing a bubble in drywall tape is to cut out the bubble with a knife. The blade should be held at a 45-degree angle. Next, apply drywall mud or joint compound to the exposed area. Make sure that the compound is mixed correctly. Once it has been set, apply a second coat of compound over the area. This will help seal the tape and smooth out the edges.<\/span><\/p>\n